Introduction

To complete this guide you will have to separate the parts of the handset in order to access the keypad. The steps of this guide are moderate in difficulty. After completing this guide, users will no longer have a sticky keypad or worn out buttons.

Set the phone with dial keys facing downward.
  • Set the phone with dial keys facing downward.

Add Comment

Slide the battery cover toward the bottom of the phone. Lift and remove the back cover from the phone.
  • Slide the battery cover toward the bottom of the phone.

  • Lift and remove the back cover from the phone.

Add Comment

Remove the battery from its compartment.
  • Remove the battery from its compartment.

  • Pinch the end of cord where the battery is attached to the phone and pull up gently.

Add Comment

Remove the two 9mm Phillips #1 screws in the battery compartment. Remove the two 9mm Phillips #1 screws in the battery compartment.
  • Remove the two 9mm Phillips #1 screws in the battery compartment.

Add Comment

Use the plastic opening tool to carefully separate the two halves of the case. Slowly work around the entire case to fully separate the halves before pulling them apart. Wires inside the case hold the two halves together, tearing these wires will lead to a need for additional repair.
  • Use the plastic opening tool to carefully separate the two halves of the case.

  • Slowly work around the entire case to fully separate the halves before pulling them apart.

  • Wires inside the case hold the two halves together, tearing these wires will lead to a need for additional repair.

Add Comment

Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board. Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board.
  • Carefully remove the 9mm Phillips #1 screw from the top corner of the circuit board.

Add Comment

Carefully grasp either side of the circuit board and lift it straight out of the front half of the case. Set the board in the lower half of the case.
  • Carefully grasp either side of the circuit board and lift it straight out of the front half of the case.

  • Set the board in the lower half of the case.

Add Comment

Remove the rubber keypad from the front half of the handset case.
  • Remove the rubber keypad from the front half of the handset case.

  • The keypad comes in two separate pieces.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

6 other people completed this guide.

Arbitrary Name

Member since: 01/28/2015

1,083 Reputation

4 Guides authored

Team

Penn State, Team 1-8, Kaschak Winter 2015 Member of Penn State, Team 1-8, Kaschak Winter 2015

PSU-KASCHAK-W15S1G8

4 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 116