Introduction

If your speaker does not function after using our troubleshooting guides, the speaker may need to be replaced. This guide will require soldering experience.

Use your fingers to peel off ear cushion by pinching and pulling off the leather.
  • Use your fingers to peel off ear cushion by pinching and pulling off the leather.

Add Comment

Use a Philips #00 head screwdriver to remove the three screws located around the speaker (9/32 in length, 1/8 inch head) The housing will come loose. Take note of the position of the wires connected to the speaker.
  • Use a Philips #00 head screwdriver to remove the three screws located around the speaker (9/32 in length, 1/8 inch head)

  • The housing will come loose. Take note of the position of the wires connected to the speaker.

Add Comment

Using the heating gun, apply heat to the 3 wires soldered to the speaker.
  • Using the heating gun, apply heat to the 3 wires soldered to the speaker.

  • Have the new speaker handy, it will require the colored wire and 2 copper wires to be soldered to it.

  • Using a soldering iron, solder the colored wire and copper wires to the positions that they were in from the previous speaker.

Add Comment

Position the speaker on the headset so that the screw holes line up. It should click into place. Screw in the 3 screws with your Philips #00 head screwdriver. Place the new cushion against speaker and wrap the leather around the plastic. Do this by working around the cushion to get all of the leather around the plastic.
  • Position the speaker on the headset so that the screw holes line up. It should click into place.

  • Screw in the 3 screws with your Philips #00 head screwdriver.

  • Place the new cushion against speaker and wrap the leather around the plastic. Do this by working around the cushion to get all of the leather around the plastic.

  • Use the plastic opening tool to tuck excess leather inside the headset.

Add Comment

Finish Line

3 other people completed this guide.

James de Iturrondo

Member since: 03/18/2015

643 Reputation

4 Guides authored

Team

2 Comments

Does the speaker driver separate from the surrounding plastic disk, so it can be replaced with a like-sized driver, or is the driver plus mounting plate assembly sold as a replacement part?

Michael Merrell - Reply

Where can a new speaker be purchased? It says that there are no parts required but in step 3 it says to have a new speaker. I can't find this online.

jn8ion - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 11

Past 30 Days: 46

All Time: 1,933