Introduction

This guide will illustrate how to replace your optical drive.

Remove the ODD screw with a #1 Phillips head screwdriver as indicated in the picture. Using a flat edge tool, pry it the drive out of it slot from the side of the casing. You can then use your hands to continue pulling the rest the way out of its slot. Using a flat edge tool, pry it the drive out of it slot from the side of the casing. You can then use your hands to continue pulling the rest the way out of its slot.
  • Remove the ODD screw with a #1 Phillips head screwdriver as indicated in the picture.

  • Using a flat edge tool, pry it the drive out of it slot from the side of the casing. You can then use your hands to continue pulling the rest the way out of its slot.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Nick

Member since: 04/16/2010

127 Reputation

2 Guides authored

Team

Cal Poly, Team 10-42, Garner Spring 2010 Member of Cal Poly, Team 10-42, Garner Spring 2010

CPSU-GARNER-S10S10G42

5 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 4

All Time: 3,165