Introduction

This guide will go through the steps needed to install a new wireless card.

  1. Turn the computer over onto its back.
    • Turn the computer over onto its back.

    Add Comment

  2. Slide the lock on the left side to the unlock position.
    • Slide the lock on the left side to the unlock position.

    • Slide the lock on the right side to the unlock position until there is a clicking sound.

    Add Comment

    • Remove the battery by sliding it out while both locks remain in the unlock position.

    Add Comment

    • Turn the computer onto the back.

    • Remove the Phillips #0 screw that secures the cover to the rest of the device.

    • One 5.1 mm coarse thread screw.

    • Pull the cover forward to release it.

    Add Comment

    • Use a Phillips #1 screwdriver to remove the two screws on opposite corners of the wireless card.

    • Two 4.0 mm coarse thread screws.

    • Use a plastic opening tool to gently lift the wireless card out while leaving the wire connected.

    Add Comment

    • Hold the edges of the wireless card and carefully disconnect the black 3 pin connector.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alison Wendt

Member since: 04/18/2013

78 Reputation

6 Guides authored

Team

Cal Poly, Team 21-51, Johann Spring 2013 Member of Cal Poly, Team 21-51, Johann Spring 2013

CPSU-JOHANN-S13S21G51

3 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 7

All Time: 570