Introduction

The power supply allows for the TiVo components to work. In the situation that it needs to be replaced, this guide will walk you through the installation of the power supply

Parts

No parts required.

Unscrew the five 0.31 inch T-9 screws on the back cover.
  • Unscrew the five 0.31 inch T-9 screws on the back cover.

Add Comment

Slide the cover towards the back until it is no longer under the front cover.
  • Slide the cover towards the back until it is no longer under the front cover.

Add Comment

  • Lift the cover up and off the device.

Add Comment

  • Locate the power supply.

Add Comment

  • Remove the belt connecting the power supply to the motherboard by pulling it out.

Add Comment

  • Remove the red, yellow, and black cable connecting the power supply to the hard drive.

Add Comment

  • Remove the two 0.31 inch T-9 screws from the power supply.

Add Comment

  • Pinch the plastic plugs and lift the power supply up to detach from plugs.

  • All 4 plugs must be detached to remove power supply.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Phil Jones

Member since: 10/11/2011

41 Reputation

1 Guide authored

Team

Cal Poly, Team 5-33, Amido Fall 2011 Member of Cal Poly, Team 5-33, Amido Fall 2011

CPSU-AMIDO-F11S5G33

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 1,047