Introduction

The throttle on the controller aids in acceleration. This guide will show you how to replace the rudder found on the throttle allowing for easier steering.

Parts

No parts required.

Be sure to disconnect the controller from the power source before disassembling.
  • Be sure to disconnect the controller from the power source before disassembling.

  • Remove the five 15 mm J1 JIS head screws from the front of the throttle.

Add Comment

Be sure to disconnect the controller from the power source before disassembling.
  • Be sure to disconnect the controller from the power source before disassembling.

  • Using your hands, pull away the panel from the throttle.

Add Comment

  • Remove the four 13 mm J1 JIS head screws from the rudder assembly holder.

Add Comment

  • Gently remove the panel that is covering the rudder.

Add Comment

  • Proceed to remove the rudder from the throttle.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Julissa Orozco

Member since: 09/20/2017

201 Reputation

2 Guides authored

Team

CSU Fullerton, Team S2-G1, Bruce Fall 2017 Member of CSU Fullerton, Team S2-G1, Bruce Fall 2017

CSUF-BRUCE-F17S2G1

3 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 11

All Time: 100