Introduction

This guide shows you how to replace the face plate of the TI-84 Plus Silver Edition. The face place is the plastic that covers the gaps in between the keys and is below the screen.

Image 1/1: Be careful to not bend the plate too much because it is very thin and might break.
  • Insert your index finger in the open slot below the keys.

  • Be careful to not bend the plate too much because it is very thin and might break.

  • Apply a firm upward force until the bottom two tabs located near the bottom of the plate come off.

Add Comment

Image 1/1: A tab is located in the center of the face plate. If it is still attached, then continue to apply a gentle upward force until the center tab comes off.
  • Grab the face plate on each side near the middle and apply a gentle upward force on each side until the middle tabs come off.

  • A tab is located in the center of the face plate. If it is still attached, then continue to apply a gentle upward force until the center tab comes off.

  • Lift the face plate upward until the top three tabs come off and the face plate is completely detached.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Agustin

Member since: 10/20/2013

465 Reputation

2 Guides authored

Team

Cal Poly, Team 11-34, Amido Fall 2013 Member of Cal Poly, Team 11-34, Amido Fall 2013

CPSU-AMIDO-F13S11G34

4 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 6

Past 7 Days: 30

Past 30 Days: 110

All Time: 5,594