Introduction

If your device no longer takes a charge, replacing the battery may breathe new life into the tablet.

Tools

No tools required.

Parts

No parts required.

Image 1/1: Remove the three #000 headed, 3 mm long screws located underneath the port cover.
  • Begin by popping open the HDMI/USB port cover on the left edge.

  • Remove the three #000 headed, 3 mm long screws located underneath the port cover.

Add Comment

Image 1/1: Remove the two screws beneath the Micro SD card slot cover.
  • There are two #000 headed, 3 mm long screws under a similar cover covering the Micro SD slot on the top side of the device.

  • Remove the two screws beneath the Micro SD card slot cover.

Add Comment

Image 1/2: Pull to remove the screen from the rest of the device. Image 2/2: Watch out for the front camera cable connected to the top middle of the device. The display ribbon cable should just slide out.
  • Attach the suction cup to the top right area of the screen.

  • Pull to remove the screen from the rest of the device.

  • Watch out for the front camera cable connected to the top middle of the device. The display ribbon cable should just slide out.

Add Comment

Image 1/1:
  • Disconnect the battery from the motherboard by pulling out the cable below the fan.

Add Comment

Image 1/1: Carefully remove the battery from the back assembly.
  • Remove the seven 3 mm Phillips #000 screws that hold the battery in place.

  • Carefully remove the battery from the back assembly.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Alexander Bridges

Member since: 09/16/2015

1,094 Reputation

7 Guides authored

Team

IUPUI, Team 1-2, Harley Fall 2015 Member of IUPUI, Team 1-2, Harley Fall 2015

IUPUI-HARLEY-F15S1G2

4 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 22

Past 30 Days: 80

All Time: 1,393