Remove charging adaptor. Some charge may still be in the battery or computer. DO NOT touch connectors or copper yellow connector.
  • Remove charging adaptor. Some charge may still be in the battery or computer. DO NOT touch connectors or copper yellow connector.

  • Locating the Battery

  • Flip Computer Toward Yourself

Add Comment

Releasing Battery
  • Releasing Battery

  • Locate two switches with the word “lock” and “release” on them.

Add Comment

  • Removing Battery

  • Push towards each other while simultaneously lifting up the battery in between the two switches.

Add Comment

  • Remove charging adaptor. Some charge may still be in the battery or computer.

  • DO NOT touch connectors or copper yellow connector.

  • The key board is attached by a screw on the back.

  • The front cover also holds the keyboard assembly.

  • Remove the memory door to access the screw for the keyboard.

  • The screws for the memory door do not come out. they are held from falling out.

Add Comment

  • Locate the screw that holds the keyboard assembly in place.

  • Remove this screw.

  • Size: L 6.7mm X D 1.9mm

Add Comment

  • Be careful of the keyboard wire connection.

  • Making sure that you when you slide the wires out. You slide from the side opposite the solder connections.

  • Flip computer over and open.

Add Comment

  • Gently pry the keyboard assembly from the front. (closest to the screen) With the blue spudger.

  • When the front of the keyboard is about two inches up. Carefully, using the blue spudger, pull out and slightly up on the connector clip. Then remove the wire connector.

  • Gently lift the key board assembly up and out.

Add Comment

  • Remove charging adaptor. Some charge may still be in the battery or computer.

  • DO NOT touch connectors or copper yellow connector.

  • Locate the fan and heat-sink.

Add Comment

  • locate the wires and connectors.

  • Gently remove the wires.

Add Comment

  • Locate the screws, and remove them.

  • Screws: L 6.7mm X D 1.9mm

Add Comment

  • Gently lift the fan assembly up and out.

Add Comment

  • Remove charging adaptor. Some charge may still be in the battery or computer.

  • DO NOT touch connectors or copper yellow connector.

  • With the covers off.

Add Comment

  • Locate and remove the screws holding the motherboard down.

  • Screws: L 4.6mm X D 1.85mm

Add Comment

  • Locate the wires and connectors.

  • Unplug all connectors that will be in the way of removing the motherboard.

Add Comment

  • Being careful of the loose connectors and wires.

  • Gently lift the motherboard out.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

One Comment

i have the same laptop, and i mistakenly remove the mother board cmos battery , and is not recognizing my laptop system hard drive.

in this case what can i do in other to restore it back.

onyebuchiadieze - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 25

All Time: 720