Introduction

The PCG F360 comes with a floppy drive in an expansion bay. This can be replaced or swapped out for a battery or for a weight saver.

Tools

No tools required.

Parts

No parts required.

  1. Position the laptop screen-side down as shown.
    • Position the laptop screen-side down as shown.

    • In this position the battery housing will be located on the right hand side.

  2. Lift the panel up and then out to gain access to the battery.
    • Lift the panel up and then out to gain access to the battery.

  3. Free shipping on all orders over $100 or containing a Pro Tech Toolkit!

    Browse Our Store
  4. Use the indentations to pull the old battery out.
    • Use the indentations to pull the old battery out.

  5. The battery is now removed and it is safe to move on to uninstalling other components.
    • The battery is now removed and it is safe to move on to uninstalling other components.

  6. With one hand slide and hold the tab shown. With your other hand, pull the floppy drive out of the floppy drive bay.
    • With one hand slide and hold the tab shown.

    • With your other hand, pull the floppy drive out of the floppy drive bay.

    • To replace the floppy drive, simply slide the drive into the slot until it clicks.

Conclusion

To reassemble your device, follow these instructions in reverse order.

ahintz

Member since: 04/21/2010

19 Reputation

8 Guides authored

Team

Cal Poly, Team 16-3, Maness Spring 2010 Member of Cal Poly, Team 16-3, Maness Spring 2010

CPSU-MANESS-S10S16G3

3 Members

8 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 2,655