Introduction

Removing the back panel on the laptop allows access to the inner components.

Power off the laptop.
  • Power off the laptop.

  • Unplug the charging cable and any other cables plugged into the laptop.

  • Failure to remove or unplug any cables could result in electric shock.

  • Turn the laptop over so that the back panel is facing upwards.

Add Comment

Locate two switches above the battery that lock it into place.
  • Locate two switches above the battery that lock it into place.

  • Push the left-hand switch, that says "lock" above it, so that it is unlocked.

Add Comment

Push and hold the right-hand switch, which says "release" above it, and lift the battery up out of its place.
  • Push and hold the right-hand switch, which says "release" above it, and lift the battery up out of its place.

Add Comment

Deck the Halls
With tools and Fix Kits
Locate and unscrew the two highlighted 8 mm Phillips #1 screws.
  • Locate and unscrew the two highlighted 8 mm Phillips #1 screws.

  • There will be three dots next to the desired screws

Add Comment

Grip the cover of the optical drive and slide it out.
  • Grip the cover of the optical drive and slide it out.

  • If it does not come out, do not force it. Double check to make sure the screws are entirely removed.

Add Comment

Remove all the 8mm Phillips #1 screws on the backside of the laptop. There are three 3mm and two 5.3mm screws under the battery that also need to be taken out. There are three 3mm screws under the optical drives that also need to be taken out.
  • Remove all the 8mm Phillips #1 screws on the backside of the laptop.

  • There are three 3mm and two 5.3mm screws under the battery that also need to be taken out.

  • There are three 3mm screws under the optical drives that also need to be taken out.

  • Remove the RAM panel in addition to the other screws. For further instructions, refer to the RAM replacement guide.

Add Comment

Pry along the edges of the back panel using the spudger. If you are struggling to remove the back panel with a moderate amount of force, do NOT apply any additional force, instead double check to make sure all the screws were removed before attempting again. If you are struggling to remove the back panel with a moderate amount of force, do NOT apply any additional force, instead double check to make sure all the screws were removed before attempting again.
  • Pry along the edges of the back panel using the spudger.

  • If you are struggling to remove the back panel with a moderate amount of force, do NOT apply any additional force, instead double check to make sure all the screws were removed before attempting again.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Sid

Member since: 05/18/2014

248 Reputation

2 Guides authored

Team

Cal Poly, Team 9-17, Regan Spring 2014 Member of Cal Poly, Team 9-17, Regan Spring 2014

CPSU-REGAN-S14S9G17

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 2

Past 7 Days: 9

Past 30 Days: 47

All Time: 3,019