Introduction

This guide will provide instruction for replacing the swivel plastic cover on the Sony Extra Bass headphones. This piece encases the swivel piece and can get damaged through wear and tear.

Parts

No parts required.

Image 1/1: Be sure to unplug the headphones from any other devices.
  • Begin by laying the headphones down flat with the speakers facing up.

  • Be sure to unplug the headphones from any other devices.

Add Comment

Image 1/2: Repeat for both the left and right screws. Image 2/2: These screws are very small. It is helpful to have a spot prepared to put the screws to avoid losing  pieces.
  • Next, take out the screws that hold the front plate, using a J00 screwdriver.

  • Repeat for both the left and right screws.

  • These screws are very small. It is helpful to have a spot prepared to put the screws to avoid losing pieces.

Add Comment

Image 1/1:
  • Now that the screws have been removed, pull away the plastic casing that covers the swivel piece (directly above the speaker).

Add Comment

Image 1/1: Repeat this process on both sides if necessary.
  • Now that the swivel piece is exposed, use a J00 screwdriver to unscrew the center screw.

  • Repeat this process on both sides if necessary.

  • This center screw is the piece that retains the swivel action, unscrew completely and remove to replace.

Add Comment

Image 1/1:
  • With the swivel screw removed, remove the plastic casing.

Add Comment

Image 1/1:
  • Using a little amount of force, slide the plastic cover off of the headband.

Add Comment

Image 1/1:
  • Pull the plastic until the cover is fully removed.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 17

Past 30 Days: 41

All Time: 110