What you need
-
-
On the back of the camera beneath the viewfinder, locate the battery pack.
-
Press the small button.
-
Slide the switch forward.
-
-
-
Remove the (6) 4.5mm screws from the bottom of the Sony Handycam that are marked with small circles.
-
-
-
-
Remove (3) 4.5mm screws from underneath the battery. Again they are marked by small arrows.
-
Remove (1) 2.9mm screw from the right corner.
-
Remove (2) 4.5mm screws from the battery right wall.
-
-
-
Remove (1) 4.5mm screw from underneath the output flap on the front of the camera right below the lens.
-
-
-
Remove the (2) 4.5mm screws from the top of the camera that are pointed out with red circles.
-
Remove the (1) 4.5 mm screw from the disk side of the camera located next to the lens. This screw is pointed out with a yellow circle.
-
-
-
Extend the gray viewfinder so the black, plastic casing will have room to come off.
-
Remove the black plastic casing gently from the top of the camera. Use caution because the plastic pieces are fragile and tend to break easily.
-
-
-
Remove (2) 2.9mm screws from under the black plastic casing that was mentioned in the previous step.
-
-
-
Note: The copper wire strip still connecting the cover to the body of the camera must be removed. It is pointed out with a red square in the slide.
-