Sony H.ear On 2 Microphone Replacement

Step 1 Ear Cup



• Start by inserting the iFixit plastic opening tool in the crease between the hard plastic and the ear cup, and then gently apply pressure until it separates. You may need to repeat the process on back until it is completely separate.
• This may take a considerable amount of pressure, but do not force it.
Step 2



• Use the JIS #00 Screwdriver to remove the five 6.4 mm screws holding the back plastic cover in place.
• Then, turn the ear cup over and carefully lift the plastic cap off to reveal the internal components of the left ear cup.
• This same process can be repeated on the right ear cup as well. Be aware the right cup is connected to the rest of the headphones via ribbon cable.
Step 3 Noise Cancelling Microphone
• Use the iFixit plastic opening tool to lift the microphone out of its housing
• Use gentle pressure to prevent damaging small wire connections
Step 4
• Use soldering iron to desolder microphone wires from motherboard
• Please see How to Solder and Desolder Connections before you attempt to use the soldering iron.
• Note: Do not overheat joints while de-soldering to prevent board damage

Author

with 6 other contributors

Justin Ramirez

Member since: 04/15/19

127 Reputation

1 Guide authored

Badges: 6

• 
• 
• 

+3 more badges

Team

Cal Poly, Team S9-G11, Maness Spring 2019 Member of Cal Poly, Team S9-G11, Maness Spring 2019

CPSU-MANESS-S19S9G11

5 Members

16 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview