Introduction

Use this guide to replace a defective Logic Board.


Please SUBSCRIBE to my channel ツ

Video Overview

Image 1/3: Remove the battery. Image 2/3: Unscrew 8x T6 Torx screws. Image 3/3: Unscrew 8x T6 Torx screws.
  • Switch-off the phone.

  • Remove the battery.

  • Unscrew 8x T6 Torx screws.

Add Comment

Image 1/3: Tip - try prying it open from the top and over to the side. It can be very tight if you are doing this for the first time. The volume rocker and camera button are not part of the housing, so try going around it. Image 2/3: Tip - try prying it open from the top and over to the side. It can be very tight if you are doing this for the first time. The volume rocker and camera button are not part of the housing, so try going around it. Image 3/3: Tip - try prying it open from the top and over to the side. It can be very tight if you are doing this for the first time. The volume rocker and camera button are not part of the housing, so try going around it.
  • Use a Plastic Pry or other plastic tool to unhook the back housing / bezel and remove it.

  • Tip - try prying it open from the top and over to the side. It can be very tight if you are doing this for the first time. The volume rocker and camera button are not part of the housing, so try going around it.

Add Comment

Image 1/3: Unhook the SIM & SD Card reader unit and disconnect the flex cable. Image 2/3: Unhook the SIM & SD Card reader unit and disconnect the flex cable. Image 3/3: Unhook the SIM & SD Card reader unit and disconnect the flex cable.
  • Remove the Volume Up/Down and Camera buttons.

  • Unhook the SIM & SD Card reader unit and disconnect the flex cable.

Remove sim card and SD card tray beforehand to avoid damaged to them

Sean Parrish - Reply

Image 1/3: Disconnect 4x flex cables: Image 2/3: LCD Display Image 3/3: Menu buttons
  • Remove the Audio jack connector.

  • Disconnect 4x flex cables:

    • LCD Display

    • Menu buttons

    • Touchscreen

    • Earpiece, Volume & Power On buttons

  • Carefully remove the mother board.

  • Please SUBSCRIBE to my channel ツ

before you can remove the mainboard, there are two nozzles at both sides of it, you have to unhook !!

blablablabla - Reply

He's right edit that in

Sean Parrish - Reply

Conclusion

To reassemble your device, follow these instructions in reverse order.

ZFix

Member since: 12/09/2013

129,349 Reputation

366 Guides authored

Team

Master Techs Member of Master Techs

Community

264 Members

613 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 23

All Time: 1,218