Fix Your Stuff Community Store

Sony Ericsson W810I Logic Board Replacement

Archived Guide
This guide is retained solely for historical purposes. Use the updated version of the guide to perform your repair.

Introduction

This guide will show the user how to remove the W810i Logic Board

What you need

  1. Sony Ericsson W810I Logic Board Replacement, Logic Board: step 1, image 1 of 1

    • Make sure the phone is off and press down firmly against the Cingular icon with your thumb

    • Slide the panel down and remove latch

    Edit

  2. Sony Ericsson W810I Logic Board Replacement: step 2, image 1 of 2 Sony Ericsson W810I Logic Board Replacement: step 2, image 2 of 2

    • Lift and pull battery out

    • Remove the SIM card if you have one

    Edit

  3. Sony Ericsson W810I Logic Board Replacement: step 3, image 1 of 1

    • Remove the two outer screws using a T-7 head for a screwdriver

    Edit

  5. Sony Ericsson W810I Logic Board Replacement: step 4, image 1 of 1

    • Remove the two smaller inner screws with the Mini-Phillips screwdriver head

    Edit

  6. Sony Ericsson W810I Logic Board Replacement: step 5, image 1 of 2 Sony Ericsson W810I Logic Board Replacement: step 5, image 2 of 2

    • Remove the Back (camera side) Faceplate with the blue hand-wedge

    Edit

  7. Sony Ericsson W810I Logic Board Replacement: step 6, image 1 of 3 Sony Ericsson W810I Logic Board Replacement: step 6, image 2 of 3 Sony Ericsson W810I Logic Board Replacement: step 6, image 3 of 3

    • Flip the phone over and pry off the front (keypad side) faceplate with multiple blue hand-wedges

    • Separate keypad from logic board by turning it upside down and allowing it to fall off

    Edit

  8. Sony Ericsson W810I Logic Board Replacement: step 7, image 1 of 2 Sony Ericsson W810I Logic Board Replacement: step 7, image 2 of 2

    • Remove the two remaining screws in the top corners of the phone using a T-6 screwdriver head

    • Remove the logic board with multiple blue hand-wedges, be careful not to snap the logic board in half, along with snapping the wiring from the logic board

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Author

with 5 other contributors

Ben Micucci

Member since: 10/14/11

186 Reputation

5 Guides authored

Badges: 8

+5 more badges

Team

James Madison, Team 2-2, Allen Fall 2011 Member of James Madison, Team 2-2, Allen Fall 2011

JMU-ALLEN-F11S2G2

2 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 1,611