Introduction

This guide will assist you in removing the speaker from your Sony Ericsson T68i.

Image 1/2: Image 2/2:
  • Remove the battery from the back.

Add Comment

Image 1/3: Do not bend it too far down, or else you risk breaking the two bottom clips. Image 2/3: Do not bend it too far down, or else you risk breaking the two bottom clips. Image 3/3: Do not bend it too far down, or else you risk breaking the two bottom clips.
  • Pry off the plastic cover from the top with a thin plastic shim, then remove it from the two bottom clips.

  • Do not bend it too far down, or else you risk breaking the two bottom clips.

Add Comment

Image 1/3: Keep in a safe place. Image 2/3: Keep in a safe place. Image 3/3: Keep in a safe place.
  • Unscrew all four Torx T6 screws.

  • Keep in a safe place.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • After removing the screws, the two halves will separate. If not, then pry them gently apart.

Add Comment

Image 1/3: Use your T6 to remove the 4 screws. Image 2/3: Use your T6 to remove the 4 screws. Image 3/3: Use your T6 to remove the 4 screws.
  • Remove the circuit board and screen from the device.

  • Use your T6 to remove the 4 screws.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Remove the board and screen.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Carefully remove the plastic clips holding the screen on the board.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Gently pry it out the speaker located in the screen housing with a small screwdriver or similar tool.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Tim Dascomb

Member since: 04/13/2010

119 Reputation

7 Guides authored

Team

Cal Poly, Team 26-34, Regan Spring 2010 Member of Cal Poly, Team 26-34, Regan Spring 2010

CPSU-REGAN-S10S26G34

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 2,090