Introduction

Some things to consider before you work on the Sony Cyber-shot DSC W800 to replace the LCD Screen:

  • The LCD Screen is an integral part of the device and any improper handling can cause issues in other parts of the camera.
  • Be cautious when removing ribbon wires.
  • Be sure to keep track of all pieces that are taken apart.
  1. Remove the five 4.0 mm Phillips #000 screws on the back panel.
    • Remove the five 4.0 mm Phillips #000 screws on the back panel.

  2. Using the Spudger, remove the back panel from the device.
    • Using the Spudger, remove the back panel from the device.

    • The loose piece circled in the picture will most likely fall off the camera housing.

    • Remove the two 2.15mm Phillips #000 screws from the circuit board.

    • Gently pull on the ribbon wire from ZIF connector with the tweezers to remove the button board.

    • Ribbon wires can easily be damaged.

    • Remove the four 3.75 mm Phillips #000 screws from the LCD back panel.

    • Lift the back panel and separate the LCD Screen by prying it up.

    • Remove the back panel.

    • Gently pull on the ribbon wire disconnecting from the ZIF connector (connecting the LCD screen to the motherboard) with the tweezers.

    • Ribbon wires can be easily damaged.

Conclusion

To reassemble your device, follow these instructions in reverse order.

2 other people completed this guide.

Thomas Campo

Member since: 02/09/2016

699 Reputation

4 Guides authored

Team

USF Tampa, Team 17-5, Blackwell Winter 2016 Member of USF Tampa, Team 17-5, Blackwell Winter 2016

USFT-BLACKWELL-W16S17G5

5 Members

5 Guides authored

0 Comments

View Statistics:

Past 24 Hours: 1

Past 7 Days: 8

Past 30 Days: 21

All Time: 909