Introduction

This guide will teach the user how to take off the back cover of the camera.

The battery compartment is located on the bottom of camera. Move the slider from the 'lock' position to the 'open' position.
  • The battery compartment is located on the bottom of camera.

  • Move the slider from the 'lock' position to the 'open' position.

Add Comment

Battery not shown. Pull battery from compartment. Insert newly charged battery into compartment, as shown in diagram (located in compartment).
  • Battery not shown.

  • Pull battery from compartment.

  • Insert newly charged battery into compartment, as shown in diagram (located in compartment).

  • Shut compartment door.

  • Move the slider back to the 'lock' position.

Add Comment

Use the Phillips #00 screwdriver to remove the 4mm length screws. There are 6 screws total.
  • Use the Phillips #00 screwdriver to remove the 4mm length screws. There are 6 screws total.

Add Comment

The 4 mm length screws are located on each side and on the bottom of the camera. 2 screws on each side (4 total). 2 screws on bottom.
  • The 4 mm length screws are located on each side and on the bottom of the camera.

  • 2 screws on each side (4 total).

  • 2 screws on bottom.

Add Comment

Gently pry around the front cover using the plastic opening tool.
  • Gently pry around the front cover using the plastic opening tool.

  • Carefully separate front cover from body of camera.

Add Comment

The front cover is now removed from the camera and the internal hardware is now visible.
  • The front cover is now removed from the camera and the internal hardware is now visible.

  • They front cover will still be connected by a ribbon. Be careful not to break the ribbon.

Add Comment

This is the camera with the front cover unscrewed and partially removed.
  • This is the camera with the front cover unscrewed and partially removed.

Add Comment

Peel the black sticker from the motherboard. Locate the connection ribbon between the front cover and the body of the device.
  • Peel the black sticker from the motherboard.

  • Locate the connection ribbon between the front cover and the body of the device.

Add Comment

Pull the ribbon out of the connection port so that they are completely disconnected. Pull the ribbon out of the connection port so that they are completely disconnected.
  • Pull the ribbon out of the connection port so that they are completely disconnected.

Add Comment

Use the plastic opening tool to separate the back cover from the inner hardware. Continue until back cover can be pulled away from inner hardware.
  • Use the plastic opening tool to separate the back cover from the inner hardware.

  • Continue until back cover can be pulled away from inner hardware.

Add Comment

Remove the back cover so that the back cover is now completely separate from the body of the device. Remove the back cover so that the back cover is now completely separate from the body of the device.
  • Remove the back cover so that the back cover is now completely separate from the body of the device.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Leslie Mundell

Member since: 03/18/2015

411 Reputation

4 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 5

All Time: 269