Introduction

The LCD screen is an essential components to the camera that will allow view-back of images. It is required to first remove the battery, the CCD black plastic housing, and the motherboard to access the LCD screen.

Image 1/1: Slide the cover towards the back of the camera.
  • Locate the cover on the bottom of the camera.

  • Slide the cover towards the back of the camera.

  • Be careful, the battery can slide out on its own.

Add Comment

Image 1/1: If it is difficult to remove, flip over the camera and the battery will slide out.
  • Carefully remove the exposed battery.

    • If it is difficult to remove, flip over the camera and the battery will slide out.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Locate and remove the 3mm screws on the top and sides of the camera with the size 00 screwdriver.

Add Comment

Image 1/1: Place the two halves down with the insides facing you.
  • Pull the two halves of the camera apart.

  • Place the two halves down with the insides facing you.

Add Comment

Image 1/1: Slide the plastic opening tool in between the ribbon and the black part of the clip, then flip it. (If difficult, your fingernail can also be used)
  • Find the two clips holding the motherboard to the black lens box.

  • Slide the plastic opening tool in between the ribbon and the black part of the clip, then flip it. (If difficult, your fingernail can also be used)

Add Comment

Image 1/1:
  • After releasing the clips, pull out black lens box.

Add Comment

Image 1/2: Image 2/2:
  • Use the plastic opening tool to flip the clip.

Add Comment

Image 1/2: This may require some force. Image 2/2: Pull out the flash.
  • Grab the white part and slide it to the right until it clicks.

    • This may require some force.

  • Pull out the flash.

Add Comment

Image 1/1:
  • Use the plastic opening tool to flip the top clip that holds the ribbon to the motherboard unit.

Add Comment

Image 1/2: Remove the four 3mm screws shown using the 00 screwdriver. Image 2/2: Remove the four 3mm screws shown using the 00 screwdriver.
  • Flip the motherboard unit up to expose the metal plate beneath it.

  • Remove the four 3mm screws shown using the 00 screwdriver.

Add Comment

Image 1/1:
  • Lift and remove the metal plate covering the LCD screen from the camera.

Add Comment

Image 1/3: Peel the tape connecting the LCD to the camera. Image 2/3: Remove LCD screen Image 3/3: Remove LCD screen
  • Flip the LCD over to the other side of the camera.

  • Peel the tape connecting the LCD to the camera.

  • Remove LCD screen

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Paul Elrich

Member since: 04/12/2012

15 Reputation

2 Guides authored

Team

Cal Poly, Team 7-35, Maness Spring 2012 Member of Cal Poly, Team 7-35, Maness Spring 2012

CPSU-MANESS-S12S7G35

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 9

Past 30 Days: 18

All Time: 1,226