Parts

No parts required.

Slide the battery latch down the side of the camera with your hands.
  • Slide the battery latch down the side of the camera with your hands.

  • The latch will automatically pop open.

Add Comment

Unlatch the clip over the battery.
  • Unlatch the clip over the battery.

  • The battery will partially pop out.

Add Comment

Remove the battery from the camera. Remove the battery from the camera.
  • Remove the battery from the camera.

Add Comment

Remove the four 3.0mm Phillips #000 screws on the top of the camera with the phillips screwdriver. Remove the additional four 3.0mm Phillips #000 screws on the bottom of the camera.
  • Remove the four 3.0mm Phillips #000 screws on the top of the camera with the phillips screwdriver.

  • Remove the additional four 3.0mm Phillips #000 screws on the bottom of the camera.

Add Comment

Deck the Halls
With tools and Fix Kits
Once the screws are removed, slowly remove the back casing from the rest of the camera. Once the screws are removed, slowly remove the back casing from the rest of the camera.
  • Once the screws are removed, slowly remove the back casing from the rest of the camera.

Add Comment

Then, pull the front case away from the rest of the camera. Then, pull the front case away from the rest of the camera.
  • Then, pull the front case away from the rest of the camera.

Add Comment

After the casing is removed, the camera should look as shown.
  • After the casing is removed, the camera should look as shown.

Add Comment

Remove the 3.0mm Phillips #000 screw above the battery door on the side of the camera.
  • Remove the 3.0mm Phillips #000 screw above the battery door on the side of the camera.

Add Comment

Pull off the pieces of casing located on either side of the top button of the camera.
  • Pull off the pieces of casing located on either side of the top button of the camera.

  • Both of the two pieces should slide off very easily. Do not force them off.

Add Comment

Remove the top button piece. You will need to detach a small blue ribbon cable before the button can be fully removed.
  • Remove the top button piece. You will need to detach a small blue ribbon cable before the button can be fully removed.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Andrew Forster

Member since: 04/16/2012

9 Reputation

2 Guides authored

Team

Cal Poly, Team 17-25, Amido Spring 2012 Member of Cal Poly, Team 17-25, Amido Spring 2012

CPSU-AMIDO-S12S17G25

4 Members

7 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 591