Introduction
This guide will show you the steps to removing and replacing the motherboard of the camera.
What you need
-
-
Place the device so bottom of the camera is facing up .
-
Remove the five black M1.4 X 3.5 Phillips head screws with a Phillips #000 screwdriver.
-
-
-
Remove the marked black M1.4 X 3.5 Phillips head screws on the side of the camera with a Phillips #000 screwdriver.
-
-
-
-
Disconnect the control board data cable by wiggling carefully with your fingertips. Set the control board to the side once it is disconnected.
-
-
-
Use the plastic opening tool with a prying motion to remove the side cover of the camera.
-
-
-
Orient the device so the lens is facing down.
-
Remove the two black M1.4 X 3.5 Phillips head screws using Phillips #000 screwdriver.
-
-
-
Orient the device so the lens is facing down.
-
Remove the black M1.4 X 3.5 Phillips head screw.
-