Fix Your Stuff Community Store

Shark Ultimate Professional Reservoir Replacement

What you need

  1. Shark Ultimate Professional Reservoir Replacement, Reservoir: step 1, image 1 of 3 Shark Ultimate Professional Reservoir Replacement, Reservoir: step 1, image 2 of 3 Shark Ultimate Professional Reservoir Replacement, Reservoir: step 1, image 3 of 3

    • Remove the two screws at the back of the iron.

    • Remove the back cover piece.

    • Make sure iron is unplugged and cooled off.

    Edit

    That #0 Phillips screwdriver does not work on my Shark Model GI 505 steam Iron. Any other ideals on how to get the cover off. The electrical cord is bad and I need to put a new cord on it. Thanks in advance.

    brucetaylor - Reply

  2. Shark Ultimate Professional Reservoir Replacement: step 2, image 1 of 2 Shark Ultimate Professional Reservoir Replacement: step 2, image 2 of 2

    • Remove the two screws holding the white clamp to the iron.

    • Remove the two screws holding the black wires to the body of the iron.

    • Removing the left black wire will also free the red wire, attached by the same screw.

    Edit

  4. Shark Ultimate Professional Reservoir Replacement: step 3, image 1 of 1

    • Pull the split end of the power cord upward through the ball joint of the iron.

    • Set aside power cord.

    Edit

  5. Shark Ultimate Professional Reservoir Replacement: step 4, image 1 of 3 Shark Ultimate Professional Reservoir Replacement: step 4, image 2 of 3 Shark Ultimate Professional Reservoir Replacement: step 4, image 3 of 3

    • Remove remaining screws that hold a wire on the bottom (brown and blue).

    • Unscrew from left to right.

    • Unclip the black adapter piece on the bottom right.

    • Wires order (from left to right): Brown, Blue, Red, Black

    Edit

  6. Shark Ultimate Professional Reservoir Replacement: step 5, image 1 of 2 Shark Ultimate Professional Reservoir Replacement: step 5, image 2 of 2

    • Remove two screws (left and right) affixed to circuit board.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

3 other people completed this guide.

Author

with 1 other contributor

Drew Carff

Member since: 10/23/17

868 Reputation

5 Guides authored

Badges: 14

+11 more badges

Team

USF Tampa, Team S1-G4, Leahy Fall 2017 Member of USF Tampa, Team S1-G4, Leahy Fall 2017

USFT-LEAHY-F17S1G4

3 Members

10 Guides authored

3 Comments

i am trying to replace the thermal cutoff but can’s remember the wire inside how to replace

primrose33166 - Reply

I have a constant leak in the vertical position - long after the iron is cold. The repair presented is well done. However it stopped short and doesn't get to the reservoir - thanks

Dalmacca-Hame - Reply

Then WHAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAAT?

Muhammad Ahmad - Reply

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 4

Past 30 Days: 24

All Time: 2,128