Skip to main content

Introduction

This guide will show you how to replace the HEPA filter which is responsible for trapping small particles that can be easily recirculated into the air. When the HEPA Filter is extremely dirty, you may want to consider replacing it.

  1. Push the red Lift Away button down and lift up on the vacuum handle to detach the base. The handle was removed for convenience but is not required.
    • Push the red Lift Away button down and lift up on the vacuum handle to detach the base.

    • The handle was removed for convenience but is not required.

  2. Remove the red cover from the front of the vacuum  by  pulling the latch found at the bottom of the cover forward and moving the whole cover downward. Remove the red cover from the front of the vacuum  by  pulling the latch found at the bottom of the cover forward and moving the whole cover downward.
    • Remove the red cover from the front of the vacuum by pulling the latch found at the bottom of the cover forward and moving the whole cover downward.

  3. Remove the filter by pulling it straight out. To clean the filter, rinse it under water and allow it to dry before placing it back in the vacuum.
    • Remove the filter by pulling it straight out.

    • To clean the filter, rinse it under water and allow it to dry before placing it back in the vacuum.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Carson Craft

Member since: 01/24/2018

234 Reputation

1 Guide authored

Team

Cal Poly, Team S19-G3, White Winter 2019 Member of Cal Poly, Team S19-G3, White Winter 2019

CPSU-WHITE-W19S19G3

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 2

Past 30 Days: 4

All Time: 186