Introduction

If you are having a problem with your device's Front Belt, Here is a Step by step guide to replace a faulty or broken Front Belt.

Parts

No parts required.

  1. Remove the two 12mm screws from the front face plate with the PH2 bit from the tool kit.
    • Remove the two 12mm screws from the front face plate with the PH2 bit from the tool kit.

  2. Once the screws are removed pull the front face plate off. This will allow access to the belt and motor.
    • Once the screws are removed pull the front face plate off. This will allow access to the belt and motor.

    • Lift the brush roller upwards towards you, and the brush roller should come out along with the belt.

    • Remove the belt from the motor mount, and then replace with a new belt.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Ben Dzugen

Member since: 02/02/2017

327 Reputation

3 Guides authored

Team

USF Tampa, Team 16-2, Blackwell Spring 2017 Member of USF Tampa, Team 16-2, Blackwell Spring 2017

USFT-BLACKWELL-S17S16G2

4 Members

6 Guides authored

One Comment

Nice and simple but where can we purchase the belts?

jmrlachance - Reply

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 33

All Time: 674