Sega Game Gear Speakers Replacement

Step 1 Battery

• Place your device upside down and locate the two battery compartments.
Step 2

• Press on the tabs at the bottom of the battery covers then lift up to remove.
• Remove batteries if they are present.
Step 3 Case
• Remove the following screws:
• Six Phillips screws
• One 4.5 mm Gamebit screw
Step 4
• Use tweezers to take all other screws out.
Step 5
• Gently open the case by unfolding it over the top of the Sega Game Gear.
• Do not pull the back of the case away, as cables are connected between both sides.
Step 6
• Carefully unplug the 2 white-tipped connectors on the top cover.
Step 7 Speakers
• Unscrew the 8 Phillips screws from the logic board.
Step 8
• Slide the logic board out from under the circular black fastener at the top-left corner of the case.
Step 9
• Removing the plastic holding the speaker to the case may permanently detach the speaker.
• The plastic at these three locations is melted to the plastic. Pry off with caution.

Author

with 9 other contributors

Lauren Thurston

Member since: 04/15/10

431 Reputation

3 Guides authored

Badges: 15

• 
• 
• 

+12 more badges

Team

Cal Poly, Team 28-33, Regan Spring 2010 Member of Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 Members

13 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview