Introduction

Guide to replace the small logic board that contains the 3.5mm headphone jack as well as the volume wheel.

Image 1/1:
  • Place your device upside down and locate the two battery compartments.

Add Comment

Image 1/1: Remove batteries if they are present.
  • Press on the tabs at the bottom of the battery covers then lift up to remove.

  • Remove batteries if they are present.

Add Comment

Image 1/1: Seven Phillips scres
  • Remove the following screws:

    • Seven Phillips scres

    • One 4.5 mm Gamebit screw

Add Comment

Image 1/1:
  • Use tweezers to take all other screws out.

Add Comment

Image 1/2: Do not pull the back of the case away, as cables are connected between both sides. Image 2/2: Do not pull the back of the case away, as cables are connected between both sides.
  • Gently open the case by unfolding it over the top of the Sega Game Gear.

  • Do not pull the back of the case away, as cables are connected between both sides.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Carefully unplug the 2 white-tipped connectors on the top cover.

Add Comment

Image 1/2: Image 2/2:
  • Unscrew the screws to remove the metal covering.

Add Comment

Image 1/1: Remove the two screws from the highlighted locations.
  • The screws that need to be removed are missing from this picture.

  • Remove the two screws from the highlighted locations.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Brandon Page

Member since: 04/15/2010

127 Reputation

2 Guides authored

Team

Cal Poly, Team 28-33, Regan Spring 2010 Member of Cal Poly, Team 28-33, Regan Spring 2010

CPSU-REGAN-S10S28G33

5 Members

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 5

Past 30 Days: 18

All Time: 5,342