Samsung S85 Rubber Door Replacement

Step 1 Rubber Door




• Remove 4 screws from bottom of camera
• Remove 2 screws from side of camera
• Remove 2 screws from side of camera
• Place Screws on magnetic surface or location where they will not roll away
Step 2

• Squeeze area noted by blue square and pull outside shell apart from remaining camera.
Step 3
• Remove 6 screws identified by red circles
• Remove 3 screws identified by orange circles
Step 4
• Gently remove orange circuit ribbon identified by red square
• Gently remove narrow orange circuit ribbon identified by blue square
Step 5
• Be very cautious when using a soldering iron (they are on average 300 F)
• Using a soldering iron, remove solder from wire identified by red circle
• Using a soldering iron, remove solder from black and red wire identified by orange circle
• Using a soldering iron, remove solder from wire identified by yellow circle
Step 6
• Using soldering iron, melt away solder and warm up metal located at top of circuit board as shown in picture
• Repeat step two to three times until board feels flexible to bend
• Slowly bend circuit board upwards (towards power button) until at 90 degree angle with remaining part of camera.
Step 7
• Remove black rubber door located on side of camera closest to lens using tweezers.
• Be careful not to bend or tear the rubber when pulling out with tweezers as it may become difficult to put back in

Author

with 2 other contributors

Avinash Salgam

Member since: 02/16/14

597 Reputation

5 Guides authored

Badges: 7

• 
• 
• 

+4 more badges

Team

University of Illinois Urbana-Champaign, Team 1-4, Scrogum Spring 2014 Member of University of Illinois Urbana-Champaign, Team 1-4, Scrogum Spring 2014

UICU-SCROGUM-S14S1G4

4 Members

10 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview