Samsung NP700Z5AH Fan Replacement

You're viewing a previously published version of this guide. View latest version

Dec 15, 2017 - 02:09:35

Dec 15, 2017 - 02:09:35 Dec 15, 2017 - 02:09:35 Dec 15, 2017 - 02:09:29 Nov 29, 2017 - 10:43:47 Nov 29, 2017 - 10:40:46 Nov 27, 2017 - 10:52:32 Nov 27, 2017 - 10:45:25 Nov 27, 2017 - 10:38:13 Nov 27, 2017 - 10:28:57 Nov 20, 2017 - 09:58:09 Nov 19, 2017 - 08:33:26 Nov 15, 2017 - 05:18:36 Nov 15, 2017 - 05:11:59 Nov 15, 2017 - 04:56:44 Nov 15, 2017 - 04:55:26 Nov 15, 2017 - 04:54:19 Nov 15, 2017 - 04:53:23 Nov 15, 2017 - 10:18:30 Nov 14, 2017 - 07:35:28 Nov 14, 2017 - 07:32:44 Nov 14, 2017 - 07:31:16 Nov 14, 2017 - 06:59:02 Nov 14, 2017 - 06:58:40 Nov 14, 2017 - 06:56:42 Nov 14, 2017 - 06:48:29 Nov 14, 2017 - 06:45:41 Nov 14, 2017 - 06:44:52 Nov 14, 2017 - 06:34:20 Nov 14, 2017 - 06:29:16 Nov 14, 2017 - 06:28:56 Nov 14, 2017 - 06:27:11 Nov 14, 2017 - 06:15:34 Nov 14, 2017 - 06:15:09 Nov 14, 2017 - 06:08:20 Nov 14, 2017 - 05:46:51 Nov 14, 2017 - 05:45:52

Newer

Introduction

This guide provides details on how to remove a dirty or broken fan from the Samsung device.

What you need

Step 1 Battery

Samsung NP700Z5AH Fan Replacement, Battery: step 1, image 1 of 1

Remove the ten 6.6mm Philips#00 screws securing the lower case to the upper case.

Step 2

Samsung NP700Z5AH Fan Replacement: step 2, image 3 of 3

Using your fingers, pinch the edge of the SD card and pull to remove it.

Step 3

Wedge your fingers in between the upper case and the lower case
Gently pull the lower case away from the upper case to remove it

Step 4

Using tweezers or your fingertips, carefully pull on the battery connector to disconnect it from the motherboard.
Be sure to pull straight backwards, or you risk damaging the wires.

Step 5

Remove the two 4.4mm Phillips#00 screws from the battery case.

Step 6

Place your fingers on the corner sections of the battery.
Lift to remove the battery.
If you choose to use tools to remove the battery be careful not to damage it. A damaged lithium-ion battery may leak dangerous chemicals and/or catch fire. Use only plastic pry tools.

Step 7 Fan

Samsung NP700Z5AH Fan Replacement, Fan: step 7, image 1 of 2

Samsung NP700Z5AH Fan Replacement, Fan: step 7, image 2 of 2

Loosen but don't remove the 7 silver Phillips #00 3.5mm screws securing the fan to the motherboard. They should detach from the motherboard and remain attached to the fan assembly.

Step 8

Using your fingers, grasp the blue ribbon on the fan connector and pull straight up to disconnect it from the motherboard.
To reinstall the cable, hold it near the end and push it straight into the connector, being careful not to kink the cable.

Step 9

Using the Phillips#00 remove the four 3.5mm screws securing the fan to the motherboard.

Step 10

Using tweezers, carefully pull up on the four power cable connectors to disconnect them from the motherboard.
These connections were originally soldered and will need a small drop of solder to be re-attached. Use this guide to learn How To Solder and Desolder Connections

Step 11

Samsung NP700Z5AH Fan Replacement: step 11, image 3 of 3

Place the tip of the spudger under the metal caps of the black and grey coaxial connectors and pry upwards to disconnect them.
After they are disconnected, un-thread them from around the fan.
To reinstall, hold the connectors in place and gently press them straight down. The connectors “snap” into their sockets much like the metal snaps on a jacket.