Samsung NP-130-JA01US Fan Replacement

Step 1 Battery

• Turn off the computer.
• Disconnect the charger cable from the computer.
• Failure to disconnect the charger cable from the computer could result in an electric shock.
• Flip the computer over so the underside is facing up.
Step 2



• Slide the left and right slider buttons fully away from each other.
Step 3
• Pull the battery out of the computer.
Step 4 Fan
• Using a Phillips 1 screwdriver, carefully remove all 12 screws of the back cover.
• The screws are Phillips 1 (PH 1) with a length of 60 millimeters (mm)
• Do not force the screwdriver as you might damage the screws.
Step 5
• With the plastic opening tool, carefully separate the back cover from the computer frame.
• Starting at one of the corners of the computer, work your way around the edge until you reach the other corner.
• Do not attempt to pry it open, putting too much force into one location might damage the computer.
• As you go around the sides of the computer, free the inside latches with the plastic opening tool.
• Once you have an opening, carefully use your hands to separate the back cover.
Step 6
• Locate the fan (marked in a red square).
Step 7
• Using a Phillips 1 screwdriver, remove the screw marked in a red circle.
• The screw is a Phillips 1 (PH 1) with a length of 40 millimeters (mm)
• Do not use too much force on the screw driver, you might damage the screw.
• Using your hands, carefully unplug the cords marked in a green square.
Step 8
• Carefully remove the fan.

Author

with 2 other contributors

Alejandro Guerra Piol

Member since: 09/12/16

319 Reputation

2 Guides authored

Badges: 12

• 
• 
• 

+9 more badges

Team

USF Tampa, Team 9-6, Lacy Fall 2016 Member of USF Tampa, Team 9-6, Lacy Fall 2016

USFT-LACY-F16S9G6

3 Members

5 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview