Introduction

The speakers in your device can be affected by a couple things such as dirt being stuck in them or simple usage over a long amount of time. Use this guide to replace them, bringing clear and new sound back to your device

Insert a metal spudger between the back case and the screen of the device.
  • Insert a metal spudger between the back case and the screen of the device.

  • The back cover is attached to the device by a series of snaps. The snaps are positioned about an inch from each other.

  • Move the spudger along the perimeter of the device while it is in between the back case and the screen to open each snap.

    • There will be an audible click every time a snap releases.

Add Comment

Remove the two 2.8 mm Phillips #000 screws from the speakers. Remove the two 2.8 mm Phillips #000 screws from the speakers.
  • Remove the two 2.8 mm Phillips #000 screws from the speakers.

Add Comment

Each speaker is now only connected to the main device by small plastic snaps.
  • Each speaker is now only connected to the main device by small plastic snaps.

  • Pry the speakers from the device at these two points using the heavy duty spudger.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Paulina Nguyen

Member since: 04/26/2017

605 Reputation

6 Guides authored

Team

Cal Poly, Team S1-G3, Livingston Spring 2017 Member of Cal Poly, Team S1-G3, Livingston Spring 2017

CPSU-LIVINGSTON-S17S1G3

1 Member

6 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 1

Past 7 Days: 5

Past 30 Days: 28

All Time: 107