Samsung Galaxy Note 10.1 2014 Charging Port Replacement

You're viewing a previously published version of this guide. View latest version

May 31, 2017 - 08:49:02

May 31, 2017 - 08:49:02 May 26, 2017 - 02:22:18 May 26, 2017 - 02:22:05 May 26, 2017 - 02:20:34 Apr 24, 2017 - 08:25:25 Apr 19, 2017 - 08:57:45 Apr 17, 2017 - 08:42:13 Apr 17, 2017 - 08:19:20 Apr 12, 2017 - 08:26:59 Apr 12, 2017 - 08:26:17 Apr 12, 2017 - 08:25:03 Apr 12, 2017 - 08:23:17 Apr 05, 2017 - 08:41:18 Apr 05, 2017 - 08:34:42 Apr 05, 2017 - 08:33:46 Apr 05, 2017 - 08:32:38 Apr 05, 2017 - 08:30:58 Apr 05, 2017 - 08:30:17

Newer

Introduction

This guide will teach you how to replace the charging port in your Samsung Galaxy 10.1 2014 edition.

What you need

Step 1 Case

Samsung Galaxy Note 10.1 2014 Charging Port Replacement, Case: step 1, image 1 of 2

Samsung Galaxy Note 10.1 2014 Charging Port Replacement, Case: step 1, image 2 of 2

Tool used on this step:

Spudger

$2.99

Buy

Using the nylon spudger or plastic opening tool along the edges of the screen, separate the back case off of the device.
If possible, consider using the black nylon spudger for a gentler separation.

Step 2 Battery

Samsung Galaxy Note 10.1 2014 Charging Port Replacement, Battery: step 2, image 1 of 1

Place your finger on the thin black bar at the end of the ribbon tape and flip each one up.
Gently pull the ribbon tape on the battery away from the bar. Repeat this process for the second ribbon tape.

Step 3

Tool used on this step:

Phillips #000 Screwdriver

$5.49

Buy

Remove the six 3mm screws around the battery with the Phillips PH000 screwdriver.

Step 4

Tool used on this step:

Spudger

$2.99

Buy

Lift up the battery from the bottom and situate the black nylon spudger underneath the battery.
Use the black nylon spudger to disconnect the multi-colored wires from the rest of the device.

Step 5 Charging Port

Samsung Galaxy Note 10.1 2014 Charging Port Replacement, Charging Port: step 5, image 1 of 1

Using the PH000 screwdriver, remove the two black 3mm screws at the bottom of the device.

Step 6

After disconnecting the two blue electronic connectors, unhinge the metal part of the charging port with the black nylon spudger.
Make sure to also disconnect the other end of the ribbon as well by pushing back the thin black metal bar.