Fix Your Stuff Community Store

Ridgid R86037 Coupler Replacement

Introduction

The coupler, like most mechanical parts, can wear down over time due to overuse. The coupler can become cracked or indented due to constant wear or failure to lubricate. The replacement of this part can be easily completed.

What you need

  1. Ridgid R86037 Coupler Replacement, Coupler: step 1, image 1 of 1

    • Using a Torx screwdriver, remove the four M2.2x1 inch screws from the end cap.

    Edit

  2. Ridgid R86037 Coupler Replacement: step 2, image 1 of 1

    • Remove the end cap from the back of the driver.

    Edit

  3. Ridgid R86037 Coupler Replacement: step 3, image 1 of 1

    • Remove the two M3.5x10 mm screws from the back of the driver under the end cap.

    Edit

  5. Ridgid R86037 Coupler Replacement: step 4, image 1 of 1

    • Remove the seven M3.5x16 mm screws from the right side of the driver.

    Edit

  6. Ridgid R86037 Coupler Replacement: step 5, image 1 of 1

    • Remove the side of the driver, exposing the inner machinery.

    Edit

  7. Ridgid R86037 Coupler Replacement: step 6, image 1 of 1

    • Remove the coupler by pulling up and releasing it from the gear assembly.

    Edit

  8. Ridgid R86037 Coupler Replacement: step 7, image 1 of 1

    • Detach the wire plug from the device and replace the old coupler with the new coupler.

    Edit
Conclusion

To reassemble your device, follow these instructions in reverse order.

4 other people completed this guide.

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 9

All Time: 668