Skip to main content

Introduction

The Motor Housing with Handle Assembly on a circular saw is one of the only pastic items on the saw which inside the saw. If Motor Housing or Handle Assembly breaks or gets damaged this guide will help replace them. Replacing the Motor Housing with Handle Assembly is very moderatly easy and doesn’t require any methods that are complicated.

  1. Remove the brush assembly with a flat head screwdriver. Remove the brush assembly with a flat head screwdriver. Remove the brush assembly with a flat head screwdriver.
    • Remove the brush assembly with a flat head screwdriver.

  2. Use a T25 Torx screwdriver to remove 3  (M5 x 58 mm) screws. Use a T25 Torx screwdriver to remove 3  (M5 x 58 mm) screws. Use a T25 Torx screwdriver to remove 3  (M5 x 58 mm) screws.
    • Use a T25 Torx screwdriver to remove 3 (M5 x 58 mm) screws.

  3. Use a T20 Torx screwdriver to remove the (1/4-20 x 0.66 in.) screw. After removing the (1/4-20 x 0.66 in.) screw the lever assembly can be unscrewed from the (1/4-20 x 0.66 in.) screw. After removing the (1/4-20 x 0.66 in.) screw the lever assembly can be unscrewed from the (1/4-20 x 0.66 in.) screw.
    • Use a T20 Torx screwdriver to remove the (1/4-20 x 0.66 in.) screw.

    • After removing the (1/4-20 x 0.66 in.) screw the lever assembly can be unscrewed from the (1/4-20 x 0.66 in.) screw.

  4. The motor housing assembly can now be removed from the rest of the saw. The motor housing assembly can now be removed from the rest of the saw.
    • The motor housing assembly can now be removed from the rest of the saw.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Joshua Caron

Member since: 04/05/2019

738 Reputation

5 Guides authored

Team

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 3

Past 30 Days: 15

All Time: 184