Introduction

This process involves removing the back cover and the front cover of the camera.

Parts

No parts required.

Image 1/2: Image 2/2:
  • Unscrew a total of seven screws from the left, right, bottom, and back sides of the camera.

Add Comment

Image 1/3: Remove back cover. After the back cover is removed, the lid of the battery compartment may fall off because it is not securely attached to anything. Image 2/3: Remove back cover. After the back cover is removed, the lid of the battery compartment may fall off because it is not securely attached to anything. Image 3/3: Remove back cover. After the back cover is removed, the lid of the battery compartment may fall off because it is not securely attached to anything.
  • To remove back cover, begin by loosening the back cover from both the left and the right sides of the camera.

  • Remove back cover. After the back cover is removed, the lid of the battery compartment may fall off because it is not securely attached to anything.

Add Comment

Image 1/3: To open the film compartment, place your finger on top of the grey latch on the left side of the camera. Image 2/3: Push down on the grey latch. The film compartment door should pop open. Image 3/3: Push down on the grey latch. The film compartment door should pop open.
  • In order to remove the front cover, the film compartment must be opened.

  • To open the film compartment, place your finger on top of the grey latch on the left side of the camera.

  • Push down on the grey latch. The film compartment door should pop open.

Add Comment

Image 1/3: To remove the film compartment door, take a thin object such as a toothpick or a small screwdriver and push down on the metal pin holding the film compartment door in place. Image 2/3: After pushing the metal pin down, use your fingers to completely remove the metal pin. Image 3/3: After the metal pin has been removed, the film compartment door can be removed.
  • The following step to remove the film compartment door is optional. However, it may aid in the maneuvering of the camera in future steps.

  • To remove the film compartment door, take a thin object such as a toothpick or a small screwdriver and push down on the metal pin holding the film compartment door in place.

  • After pushing the metal pin down, use your fingers to completely remove the metal pin.

  • After the metal pin has been removed, the film compartment door can be removed.

Add Comment

Image 1/2: Image 2/2:
  • Unscrew two screws from within the film compartment. These screws are located at the bottom left and the middle right and require a thin shaft screwdriver.

Add Comment

Image 1/3: Remove the front cover. Image 2/3: Remove the front cover. Image 3/3: Remove the front cover.
  • To remove the front cover, begin by loosening the front cover from the left and the right sides of the camera.

  • Remove the front cover.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Eric Dazet

Member since: 04/10/2012

343 Reputation

5 Guides authored

Team

Cal Poly, Team 6-21, Amido Spring 2012 Member of Cal Poly, Team 6-21, Amido Spring 2012

CPSU-AMIDO-S12S6G21

4 Members

9 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 185