Introduction

The purpose of this guide is to demonstrate how to locate and remove the 1150 Wireless MiniPCI Card.

Parts

No parts required.

Image 1/3: Unscrew the single screw holding the cover in place. Image 2/3: lift up the cover and remove it to exposed the Wireless MiniPCI Card. Image 3/3: lift up the cover and remove it to exposed the Wireless MiniPCI Card.
  • Turn the laptop upside down and locate the panel labeled C.

  • Unscrew the single screw holding the cover in place.

  • lift up the cover and remove it to exposed the Wireless MiniPCI Card.

Add Comment

Image 1/2: The grey and black wires are the antenna wires so be careful not to damage them Image 2/2: Gently pull the retaining clips away from the board so that the board pops up.
  • Using a plastic spudger or similar, gently pry the grey and black wires off.

  • The grey and black wires are the antenna wires so be careful not to damage them

  • Gently pull the retaining clips away from the board so that the board pops up.

Add Comment

Image 1/1:
  • Lift the board up and out of the mini PCI slot at an angle of about 35 - 45 degrees

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Teja

Member since: 04/27/2010

98 Reputation

3 Guides authored

Team

Cal Poly, Team 16-2, Maness Spring 2010 Member of Cal Poly, Team 16-2, Maness Spring 2010

CPSU-MANESS-S10S16G2

4 Members

8 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 2

All Time: 5,422