Introduction

First step to repairing RIDGID drill. All it takes is getting the case off...

  1. Remove the backplate.
    • Remove the backplate.

    • Using a Torx T20 screwdriver, remove the four screws attaching the back plate.

    Add Comment

  2. Free shipping on orders over $20
    Use code BLUEANDBLACK at checkout
    Free shipping on orders over $20
    Use code BLUEANDBLACK
  3. Remove the drill handle.
    • Remove the drill handle.

    • Using the Phillips #2 screwdriver, remove the five screws attaching the drill handle to the body.

    Add Comment

    • Remove the gear casing from the body.

    • Using the Philips #2 screwdriver, remove the four screws attaching the gear casing to the body.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Evan Long

Member since: 04/15/2010

232 Reputation

4 Guides authored

Team

Cal Poly, Team 15-48, Garner Spring 2010 Member of Cal Poly, Team 15-48, Garner Spring 2010

CPSU-GARNER-S10S15G48

6 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 4

All Time: 3,699