RCA RCT6203W46 Rear Speaker Replacement

You're viewing a previously published version of this guide. View latest version

Dec 18, 2016 - 10:22:57

Dec 18, 2016 - 10:22:57 Dec 18, 2016 - 10:22:55 Dec 18, 2016 - 10:22:11 Nov 28, 2016 - 01:49:42 Nov 28, 2016 - 01:47:47 Nov 28, 2016 - 01:10:03 Oct 28, 2016 - 10:58:06 Oct 26, 2016 - 12:28:22 Oct 26, 2016 - 12:09:12 Oct 26, 2016 - 11:55:48 Oct 26, 2016 - 11:55:23 Oct 26, 2016 - 11:55:13 Oct 26, 2016 - 11:55:03 Oct 26, 2016 - 11:54:27 Oct 23, 2016 - 08:29:00 Oct 23, 2016 - 08:26:15 Oct 23, 2016 - 08:26:03 Oct 23, 2016 - 08:25:51 Oct 23, 2016 - 08:22:43 Oct 23, 2016 - 08:22:13 Oct 23, 2016 - 08:21:24 Oct 23, 2016 - 08:14:00 Oct 23, 2016 - 08:09:21 Oct 23, 2016 - 08:07:45 Oct 23, 2016 - 08:05:47 Oct 23, 2016 - 08:05:34 Oct 23, 2016 - 08:01:38 Oct 23, 2016 - 08:01:15 Oct 23, 2016 - 08:00:17 Oct 23, 2016 - 07:59:48 Oct 23, 2016 - 07:59:00 Oct 23, 2016 - 06:54:28 Oct 19, 2016 - 01:21:52 Oct 19, 2016 - 01:19:41

Newer

Introduction

In order to reach the rear speaker, the back of the tablet must be removed. This guide requires basic knowledge of soldering.

What you need

Step 1 Rear Speaker

RCA RCT6203W46 Rear Speaker Replacement, Rear Speaker: step 1, image 1 of 2

RCA RCT6203W46 Rear Speaker Replacement, Rear Speaker: step 1, image 2 of 2

Remove these four 4 mm Phillips #00 screws.

Step 2

Run a spudger tool around the edge of the screen to loosen it and begin to pry upward.
The screen will be able to be removed once you see it pop up like it has in the photo.
There are wires attached to the back cover and screen so be careful not to pull them apart.