Introduction

In order to reach the rear speaker, the back of the tablet must be removed. This guide requires basic knowledge of soldering.

Remove these four 4 mm Phillips #00 screws. Remove these four 4 mm Phillips #00 screws.
  • Remove these four 4 mm Phillips #00 screws.

Add Comment

Run a spudger tool around the edge of the screen to loosen it and begin to pry upward. The screen will be able to be removed once you see it pop up like it has in the photo.
  • Run a spudger tool around the edge of the screen to loosen it and begin to pry upward.

  • The screen will be able to be removed once you see it pop up like it has in the photo.

  • There are wires attached to the back cover and screen so be careful not to pull them apart.

Add Comment

Deck the Halls
With tools and Fix Kits
With a soldering iron, remove the wires from the circuit board. Due to the size of the wires, tweezers may be necessary. Due to the size of the wires, tweezers may be necessary.
  • With a soldering iron, remove the wires from the circuit board.

  • Due to the size of the wires, tweezers may be necessary.

Add Comment

Use a metal spudger to pry out the speakers from its housing.
  • Use a metal spudger to pry out the speakers from its housing.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Nicholas Alexander

Member since: 09/21/2016

282 Reputation

2 Guides authored

Team

UC Davis, Team 1-2, Oliver Fall 2016 Member of UC Davis, Team 1-2, Oliver Fall 2016

UCD-OLIVER-F16S1G2

5 Members

4 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 5

All Time: 114