Protocol Vento Motor Replacement

Step 1 Battery

• Grasp the tail end of the drone where the lip of the battery protrudes.
Step 2

• Pull away from the drone to remove the battery.
• Do not attempt any repairs or replacements before removing the battery from the drone.
Step 3 Propeller
• Place a prying tool under the base of the propeller.
Step 4
• Use a moderate amount of force to pry the propeller out of its base. The propeller should pop off.
Step 5 Motor
• Unscrew the 4.9mm Phillips #000 screw that is located at the end of the drone's arm.
Step 6
• Hold the base of the arm while gently pulling the motor cover away from the arm.
• Do not pull too hard because there are wires attaching the motor to the drone. Do not sever the wires.
Step 7
• Gently pull the motor out from the plastic cover.
• Do not squeeze or pull too hard, as to not damage the motor connection.
Step 8
• The motor’s blue and red wires are secured via a white clip. This clip is inserted into a slot in the drone’s leg.
• Grasp the clip’s edges with a pair of tweezers and pull outward.
• Do not pull directly on the wires, as to not separate the wires from the clip.

Author

with 4 other contributors

Maria Larcomb

Member since: 02/15/18

926 Reputation

5 Guides authored

Badges: 18

• 
• 
• 

+15 more badges

Team

USF Tampa, Team S1-G2, Leahy Spring 2018 Member of USF Tampa, Team S1-G2, Leahy Spring 2018

USFT-LEAHY-S18S1G2

4 Members

6 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview