Introduction

56k internal modem, standard on all models.

  1. Use your thumbs to push the two battery retaining tabs away from the battery.
    • Use your thumbs to push the two battery retaining tabs away from the battery.

    • The battery should pop up enough to rotate it toward yourself and lift it out of the lower case.

    Add Comment

  2. Remove the three 2.3 mm Phillips screws securing the memory cover to the lower case.
    • Remove the three 2.3 mm Phillips screws securing the memory cover to the lower case.

    Add Comment

    • Lift the memory cover slightly and pull it toward yourself to remove it from the lower case.

    Add Comment

    • Remove the strip of tape covering the speaker cables.

    Add Comment

    • Disconnect the RJ-11 cable from the modem.

    Add Comment

  3. Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    Spread Fixmas Cheer
    Get $12 off your purchase of $50 or more with code FIXMAS12
    • Use your fingernails or the tip of a spudger to separate the ZIF cable lock from its socket.

    • The ZIF cable lock will move about 1 mm and stop. Do not attempt to completely remove the ZIF cable lock.

    Add Comment

    • Pull the DC-in cable out of its socket.

    Add Comment

    • Peel the DC-in cable off the adhesive securing it to the lower case.

    Add Comment

    • Use the tip of a spudger to remove the piece of foam tape from the channel on the side of the left speaker.

    • De-route the cables from the channel in the left speaker.

    Add Comment

    • Remove the single T8 Torx screw securing the left speaker to the lower case.

    • Lift the left speaker from its rear edge and maneuver it out of the lower case, minding the cables sitting in the channel near the front edge of the left speaker.

    • Set the speaker next to the lower case.

    Add Comment

    • Pull the DC power cable connector straight up off the DC-in board.

    Add Comment

    • Remove the two T8 Torx screws securing the DC-in board to the lower case.

    • New line.

    Add Comment

    • Pull the DC-in board away from the side of the lower case to separate the ports from their bezel.

    • Lift the DC-in board out of the lower case.

    Add Comment

    • Use your thumbs to slide the RJ-11 board slightly away from the DC-In board.

    Add Comment

    • Use the flat end of a spudger to continue removing the RJ-11 board away from the DC-In board.

    Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Attached Documents

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 1,820