Introduction

Removing the heat shield enables access to the RAM and processor beneath.

Remove both expansion bay modules using the levers on the front of the computer.
  • Remove both expansion bay modules using the levers on the front of the computer.

  • Insert your index fingers inside the expansion bays and search for the two ribbed tabs on the underside of the upper case. The tabs are located near the bottom corners of the keyboard.

  • Pull the tabs toward yourself and the keyboard will pop up.

Add Comment

Pull the keyboard forward to disengage the tabs holding it in back and rotate it toward you.
  • Pull the keyboard forward to disengage the tabs holding it in back and rotate it toward you.

  • Rest the keyboard on the trackpad.

Add Comment

  • This is a diagram of the ribbon clamp connectors you will disconnect in the next step.

  • 1) With your fingernails, grasp the locking bar on either side and pull up a small amount (about 1/16" or 2 mm).

  • 2) After disengaging the locking bar, slide the cable out of the connector.

Add Comment

Black Friday
Broken doesn't stand a chance.
Disconnect the two keyboard connectors by disengaging the clamps and pulling the ribbons directly upward.
  • Disconnect the two keyboard connectors by disengaging the clamps and pulling the ribbons directly upward.

Add Comment

Slide a spudger downward between each plastic strain relief cable and the wall of the case in order to bow out the cable beyond the small tab holding it in place.
  • Slide a spudger downward between each plastic strain relief cable and the wall of the case in order to bow out the cable beyond the small tab holding it in place.

  • Once the strain relief cables are free, lift the keyboard off.

Add Comment

Your laptop should look approximately like this.
  • Your laptop should look approximately like this.

Add Comment

Remove the two Phillips screws from the heat shield.
  • Remove the two Phillips screws from the heat shield.

  • One screw is shorter than the other. When putting the Wallstreet back together, this screw goes in the middle of the heat shield.

Add Comment

Grasp the metal handle on the heat shield and pull up and toward yourself.
  • Grasp the metal handle on the heat shield and pull up and toward yourself.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

One other person completed this guide.

Attached Documents

iRobot

Member since: 09/24/2009

1 Reputation

726 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 3

All Time: 3,379