Installing Apple PowerMac G4 Cube RAM

Step 1 Outer Case




• Release the back handle of the PowerMac. Slowly pull out the cube by holding the end of the handle. Watch for any parts that may become entangled with the outer case.
• Push back the handle after you have taken the core out of the case.
Step 2



• Place the cube upside down and remove the four T10 Torx screws on the front plate. Then remove the two screws on each side.
Step 3
• Slowly lift the plate off the cube and disconnect the power cord.
Step 4
• Remove the four pillars from each corner.
• The pillars should come out fairly easily.
Step 5 RAM
• Flip the two latches on the side of the RAM chip.
• Remove the chip from the logic board and replace with new RAM.

Author

with 7 other contributors

Ryan Chun

Member since: 06/24/10

1,076 Reputation

7 Guides authored

Badges: 13

• 
• 
• 

+10 more badges

Team

Cal Poly, Team 2-7, Johann Summer 2010 Member of Cal Poly, Team 2-7, Johann Summer 2010

CPSU-JOHANN-R10S2G7

5 Members

14 Guides authored

Embed this guide

Choose a size and copy the code below to embed this guide as a small widget on your site / forum.

Preview