Skip to main content

You're viewing a previously published version of this guide.  View latest version

Older Newer

Introduction

Replacement guide for the screen of the Pebble Time.

Parts

No parts specified.

  1. Lay the watch flat on your workstation.
    • Lay the watch flat on your workstation.

  2. Use the metal spudger to carefully pull apart the screen cover from the case. Replace the metal spudger with a plastic opening tool to hold the cover open.
    • Use the metal spudger to carefully pull apart the screen cover from the case.

    • Replace the metal spudger with a plastic opening tool to hold the cover open.

  3. Use the metal spudger tool to carefully loosen the rest of the cover.
    • Use the metal spudger tool to carefully loosen the rest of the cover.

  4. Carefully, pull apart the cover with the plastic opening tool.
    • Carefully, pull apart the cover with the plastic opening tool.

  5. Insert metal spudger into the side of the screen shown in the picture.
    • Insert metal spudger into the side of the screen shown in the picture.

  6. Use the metal spudger to pry the screen up.
    • Use the metal spudger to pry the screen up.

  7. Once screen is lifted, insert plastic opening tool between the screen connector and circuit board. Disconnect the screen from the circuit board. Disconnect the screen from the circuit board.
    • Once screen is lifted, insert plastic opening tool between the screen connector and circuit board.

    • Disconnect the screen from the circuit board.

Saud Al-Malki

Member since: 02/19/2017

110 Reputation

1 Guide authored

Team

USF Tampa, Team 1-3, Sullivan Spring 2017 Member of USF Tampa, Team 1-3, Sullivan Spring 2017

USFT-SULLIVAN-S17S1G3

4 Members

7 Guides authored

View Statistics:

Past 24 Hours: 2

Past 7 Days: 5

Past 30 Days: 12

All Time: 2,392