Introduction

The Parrot Hydrofoil Orak drone not only flies in the air, but it also sails in the water. The drone's outriggers, attached to the hydrofoil supports, play an important part in keeping the Orak afloat on the water. If the outriggers are broken or faulty, the drone might not operate correctly on the water. If this is the case, follow this guide in order to replace them.

Parts

No parts required.

Place the drone so that the nose of the boat is pointing to the right.
  • Place the drone so that the nose of the boat is pointing to the right.

Add Comment

Unscrew the 1 cm screw on the end of the plastic arm and connected to the foam outrigger using the T8 screwdriver fitting. Remove the outrigger from the plastic arm. Remove the outrigger from the plastic arm.
  • Unscrew the 1 cm screw on the end of the plastic arm and connected to the foam outrigger using the T8 screwdriver fitting.

  • Remove the outrigger from the plastic arm.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Alex Ziemann

Member since: 10/06/2016

135 Reputation

1 Guide authored

Team

Cal Poly, Team 20-2, Livingston Fall 2016 Member of Cal Poly, Team 20-2, Livingston Fall 2016

CPSU-LIVINGSTON-F16S20G2

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 1

All Time: 34