Parrot Hydrofoil Orak Lever Arm Replacement

Introduction

This guide will detail the process for removing the lever arm on the hydrofoil boat. If the lever arm won't raise when the drone is powered on or is broken, you may need to use this guide to access and remove the lever arm.

What you need

Step 1 Rudder

Parrot Hydrofoil Orak Lever Arm Replacement, Rudder: step 1, image 1 of 1

Place the boat so that the front faces to the right.

Edit

Step 2

Remove the far left 1cm screw using a T8 screwdriver.

Edit

Step 3

Remove the rudder.

Edit

Step 4 Lever Arm

Parrot Hydrofoil Orak Lever Arm Replacement, Lever Arm: step 4, image 1 of 3

Parrot Hydrofoil Orak Lever Arm Replacement, Lever Arm: step 4, image 2 of 3

Parrot Hydrofoil Orak Lever Arm Replacement, Lever Arm: step 4, image 3 of 3

Remove the four remaining 1cm screws with the T8 screw driver.

Edit

Step 5

Lift up on the plastic piece that is securing the lever arm.

Edit

Step 6

Flip the plastic part upside down to reveal where the lever arm sits.

Edit

Step 7

Parrot Hydrofoil Orak Lever Arm Replacement: step 7, image 3 of 3

Lift the lever arm from the slot it is in and slide off of the end of the plastic piece that was holding it to the boat.

Edit

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

with 1 other contributor

Justin Connerly

Member since: 10/06/16

273 Reputation

2 Guides authored

Badges: 9

+6 more badges

Team

Cal Poly, Team 20-2, Livingston Fall 2016 Member of Cal Poly, Team 20-2, Livingston Fall 2016

CPSU-LIVINGSTON-F16S20G2

4 Members

5 Guides authored

Parrot Hydrofoil Orak Lever Arm Replacement

Introduction

What you need

Step 1 Rudder

Add Comment

Step 2

Add Comment

Step 3

Add Comment

Step 4 Lever Arm

Add Comment

Step 5

Add Comment

Step 6

Add Comment

Step 7

Add Comment

Author

Justin Connerly

Team

Cal Poly, Team 20-2, Livingston Fall 2016 Member of Cal Poly, Team 20-2, Livingston Fall 2016

0 Comments

Add Comment

Embed this guide

Preview