Skip to main content

Panasonic Lumix DMC-ZS3 Back Cover Replacement

What you need

  1. Panasonic Lumix DMC-ZS3 Back Cover Replacement, Back Cover: step 1, image 1 of 3 Panasonic Lumix DMC-ZS3 Back Cover Replacement, Back Cover: step 1, image 2 of 3 Panasonic Lumix DMC-ZS3 Back Cover Replacement, Back Cover: step 1, image 3 of 3
    • Remove the following eleven screws securing the covers to the ZS3

    • Eleven 3 mm Phillips screws

    • Using too much pressure when removing the screws may strip the screws and complicate screw removal at a later time.

  2. Panasonic Lumix DMC-ZS3 Back Cover Replacement: step 2, image 1 of 2 Panasonic Lumix DMC-ZS3 Back Cover Replacement: step 2, image 2 of 2
    • Use the flat end of a spudger to pry apart the back cover from the rest of the unit as shown.

    • Be sure to carefully and slowly lift the back cover. Forcefully lifting the back cover and fully separating it at this point may ruin internal connections.

  3. Panasonic Lumix DMC-ZS3 Back Cover Replacement: step 3, image 1 of 2 Panasonic Lumix DMC-ZS3 Back Cover Replacement: step 3, image 2 of 2
    • Using your fingernail or a spudger, flip up the ZIF locking flap on the two LCD ribbon cable sockets that connect the back cover to the rest of the unit.

    • Be sure you are opening the locking tab, not pulling against the socket mounted to the board.

  4. Panasonic Lumix DMC-ZS3 Back Cover Replacement: step 4, image 1 of 1
    • Remove the two LCD board ribbon cables out of their sockets.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Team

Cal Poly, Team 13-60, Johann Spring 2013 Member of Cal Poly, Team 13-60, Johann Spring 2013

CPSU-JOHANN-S13S13G60

3 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 8

All Time: 770