Introduction

The LCD screen is one of the most vital components of the camera. It conveniently shows you the pictures you have taken with your camera and displays the options and settings for your camera.

Parts

No parts required.

Image 1/1: The door will automatically swing open after you let it go.
  • Move the switch on the battery door to the Open position.

  • The door will automatically swing open after you let it go.

Add Comment

Image 1/2: Keep your finger clear of the battery when it pops out. Image 2/2: Keep your finger clear of the battery when it pops out.
  • Push the small gray tab on the top right corner to the left. The battery will pop out slightly.

  • Keep your finger clear of the battery when it pops out.

Add Comment

Image 1/1: The memory card will pop out slightly.
  • Push the memory card in and let go.

  • The memory card will pop out slightly.

  • Pull out the memory card.

Add Comment

Image 1/2: The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm). Image 2/2: The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm).
  • Unscrew the small screws on the sides of the camera.

  • The screws on the left side(#00P, 4.7mm) are longer than the screw on the right side(#00P, 3.3mm).

Add Comment

Image 1/2: The bottom will fall off. Image 2/2: The bottom will fall off.
  • Unscrew the three small screws on the bottom(#00P, 3.3mm).

  • The bottom will fall off.

Add Comment

Image 1/3: Gently lift up the back cover with your hand from the bottom to the top. Image 2/3: Gently lift up the back cover with your hand from the bottom to the top. Image 3/3: Gently lift up the back cover with your hand from the bottom to the top.
  • Lift up the bottom back cover by prying the bottom edge with the spudger.

  • Gently lift up the back cover with your hand from the bottom to the top.

Add Comment

Image 1/3: The ribbon cables should easily come out of the ZIF connectors. Image 2/3: The ribbon cables should easily come out of the ZIF connectors. Image 3/3: The ribbon cables should easily come out of the ZIF connectors.
  • Lift the tabs on the ZIF connectors.

  • The ribbon cables should easily come out of the ZIF connectors.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Use the pointed end of the spudger to pry off the LCD screen from the back cover. Place the tip of the spudger in the small hole in the bracket on the LCD screen and lift it out.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

James Cruz

Member since: 04/14/2012

6 Reputation

1 Guide authored

Team

Cal Poly, Team 6-23, Amido Spring 2012 Member of Cal Poly, Team 6-23, Amido Spring 2012

CPSU-AMIDO-S12S6G23

4 Members

10 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 5

Past 30 Days: 12

All Time: 1,267