Introduction

Remove the left side cover of the camcorder and little pieces in the left side in order to get to the anchors of the hand strap that allow you to remove it.

Parts

No parts required.

Image 1/3: Unscrew the marked screws on the bottom of the camcorder. Image 2/3: Unscrew the marked screws on the back of the camcorder. Image 3/3: Unscrew the marked screws on the back of the camcorder.
  • Unscrew the J1 screws on the left side of the camcorder.

  • Unscrew the marked screws on the bottom of the camcorder.

  • Unscrew the marked screws on the back of the camcorder.

Add Comment

Image 1/2: Image 2/2:
  • Pull off the left side of the camcorder. You may have to use a little force but don't worry about breaking anything in the camcorder.

Add Comment

Image 1/1:
  • Unscrew the indicated screw.

Add Comment

Image 1/1:
  • Lift up on the little tab indicated in the picture and push away from the camera in order to remove the record button.

Add Comment

Image 1/3: Image 2/3: Image 3/3:
  • Take out the piece that that was held in place by the screw and separate the smaller piece from the larger piece.

Add Comment

Image 1/1:
  • Use the plastic opening tool to pry the little metal bar out of place in order to release one side of the hand strap.

Add Comment

Image 1/1:
  • Unscrew the indicated screws and remove the piece it was holding in place.

Add Comment

Image 1/1:
  • Repeat step 3 for this side of the strap.

Add Comment

Image 1/1:
  • Pull the handle straps out of their holes to remove the strap.

Add Comment

Conclusion

To reassemble your device, follow these instructions in reverse order.

Rebecca Maloney

Member since: 01/24/2017

501 Reputation

5 Guides authored

Team

Cal Poly, Team 13-6, Banghart Winter 2017 Member of Cal Poly, Team 13-6, Banghart Winter 2017

CPSU-BANGHART-W17S13G6

4 Members

5 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 32