Introduction
By following the steps in this guide in order, you will be able to remove and replace the broken motherboard of your Oregon Scientific Meep! 4.0 tablet.
What you need
-
-
Use a screwdriver to remove the four 7.0 mm Philips #00 screws from the back of the device.
-
-
-
-
Use a soldering station to disconnect any wires attached to the motherboard.
-
To reassemble your device, follow these instructions in reverse order.
To reassemble your device, follow these instructions in reverse order.
Cancel: I did not complete this guide.
One other person completed this guide.
Team
University of Tampa, Team 1-3, Whiteside Fall 2015 Member of University of Tampa, Team 1-3, Whiteside Fall 2015
UT-WHITESIDE-F15S1G3
3 Members
12 Guides authored
